Forester F4-2.5L Turbo (2009)
PART INFORMATION
SERVICE INFORMATION/PROCEDURE
1) The damping sheet will need to be cut into the following sizes:
^ 1 - 120mm X 100mm.
^ 1 - 30mm X 100mm.
2) Remove inside of the left rear lateral link. (See picture below.)
a) Remove the lower bolt of the stabilizer link from the lateral link.
b) Remove the lower nut from the rear shock absorber.
c) Remove the bolt securing the rear lateral link to the cross member.
d) Pull the lateral link down to gain access to apply the sheets.
3) Clean and degrease the areas shown below.
