Forester F4-2.5L Turbo (2009)
9. Remove the fuel sub level sensor.
INSTALLATION
Install in the reverse order of removal while being careful of the following.
-
Make sure the sealing portion is free from fuel or foreign matter before installation.
-
Align the protrusion (A) of gasket to the position shown in the following figure.
-
Align the protrusion (B) of fuel sub level sensor with the cutout portion of fuel sub level sensor upper plate.
-
Tighten the nuts and bolts to the specified torque in the order as shown in the figure.
NOTE: Use a new gasket and retainer.