Forester F4-2.5L Turbo (2009)
Clutch Switch: Service and Repair
Clutch Switch
REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover.
3) Disconnect the connector of clutch switch.
4) Remove the clutch switches.
INSTALLATION
CLUTCH SWITCH (CRUISE CONTROL)
1) Move the clevis pin of push rod to left and right, retain it at the position where it moves smoothly, and measure the clutch pedal stroke.
Clutch pedal full stroke A:
130 - 135 mm (5.12 - 5.31 in)
Tightening torque:
T: 8 N-m (0.8 kgf-m, 5.9 ft-lb)
2) If the clutch pedal stroke is out of specification, adjust the stroke.
3) Connect the clutch switch connector.
CLUTCH SWITCH (CLUTCH START)
1) Fully depress the clutch and hold it.
2) Install the clutch pedal plate and clutch switch so that the gap between them is 3.1 - 4.1 mm (0.12 - 0.16 in), and then tighten the lock nut.
Tightening torque:
8 N-m (0.8 kgf-m, 5.9 ft-lb)
3) Connect the clutch switch connector.
4) Make sure that engine does not start with clutch pedal not depressed.