Forester F4-2.5L Turbo (2009)
^
Non-turbo model
^
Turbo model
5) Connect the connector to the power steering pump switch.
6) Install the V-belts to the oil pump.
7) Check the tension of the V-belt.
8) Tighten the belt tension bolt.
Tightening torque:
25 N-m (2.5 kgf-m, 18.4 ft-lb)
9) Install the pulley belt cover.
10) Install the air intake duct.
11) Connect the ground cable to the battery.
12) Fill with the specified power steering fluid.
CAUTION:
Never start the engine before filling with fluid; otherwise the vane pump may become seized.