Forester F4-2.5L Turbo (2009)
Shift Cable: Procedures
Inspection
INSPECTION
Check the removed cable and replace or adjust if damaged, rusty or malfunctioning.
1) Check the cable for smooth operation.
2) Check the inner cable for damage and rust.
3) Check the outer cable for damage, bends and cracks.
4) Check the boot for damage, cracks, and deterioration.
5) Move the select lever from "P" to "D" range. Check the existence of feel to contact the detents in each range. If the detents cannot be felt or the
position pointer is improperly aligned, adjust the cable.
6) Check if the starter motor rotates when the select lever is set to "P" range.
7) Check the back-up light illumination when the select lever is in "R" range.
8) Check the parking lock operation when the select lever is in "P" range.
Adjustment
ADJUSTMENT
1) Set the vehicle on a lift.
2) Shift the select lever to "N" range.
3) Lift up the vehicle.
4) Remove the rear exhaust pipe and muffler.
5) Remove the heat shield cover.
6) Loosen the adjusting nuts on both sides.
7) Turn adjusting nut B until it lightly touches the connector.
