Forester F4-2.5L Turbo (2009)
11) Remove the front drive shaft assembly. If it is hard to remove, use ST1 and ST2.
ST1 926470000 AXLE SHAFT PULLER
ST2 28099PA110 AXLE SHAFT PULLER PLATE
12) Using a bar, remove the front drive shaft from transmission.
CAUTION:
Be careful not to allow the bar to damage holder area.
Front Drive Shaft Installation
INSTALLATION
1) Replace the differential side retainer oil seal with a new part.
NOTE:
After pulling out the drive shaft, be sure to replace with a new oil seal.
2) Insert the EBJ into the hub spline.
3) Draw the drive shaft into specified position.
CAUTION:
Do not hammer drive shaft when installing it.
4) Tighten the axle nut temporarily.
5) Using the ST, install the front drive shaft to transmission.
ST 28399SA010 OIL SEAL PROTECTOR
