Forester F4-2.5L Turbo (2009)
Front Drive Shaft Assembly
ASSEMBLY
1) Roll up a thick sheet of paper, etc. to a size where the shaft can fit inside, and affix with tape to make a cylinder.
2) Attach a new O-ring on this cylinder.
CAUTION:
^
Always use a new O-ring.
^
Be careful that the O-ring does not become scratched and that there are no foreign objects attached to it.
^
Make sure to install the O-ring so that it does not twist as much as possible.
^
Do not stretch the O-ring to 30 mm (1.18 in) inner diameter or more.
3) Pass the cylinder material onto the shaft, and slide in the direction of the shaft axis.
4) Clean the shaft boot groove, and wipe off the grease.
5) Slide the cylinder material near the shaft boot groove, and move the O-ring from the cylinder material onto the shaft boot groove.
CAUTION:
