Forester F4-2.5L Turbo (2009)
^
Attach the O-ring to the shaft boot groove center.
^
Be careful that the O-ring does not become scratched and that there are no foreign objects attached to it.
^
Make sure to install the O-ring so that it does not twist as much as possible.
^
With the O-ring attached, do not wash with kerosene, gasoline, etc.
6) Pass the PTJ small diameter boot band through the shaft.
7) Wrap vinyl tape around the splines of the shaft.
CAUTION:
To prevent damage to the boots, make sure to always wrap with vinyl tape for protection.
8) Install a new PTJ boot.
CAUTION:
Make sure to fit securely on the boot groove of the shaft.
9) Match the alignment marks, and attach the trunnion onto the shaft.
10) Attach the snap ring to the shaft.
CAUTION:
Confirm that the snap ring is completely fitted in the shaft groove.
11) Fill 100 to 110 g (3.53 to 3.88 oz) of specified grease into the interior of the PTJ outer race.
Grease:
NKG302
12) Apply a thin coat of specified grease to the roller kit and trunnion.
13) Match the alignment marks of the roller kit and trunnion, and attach the roller kit.
CAUTION:
Be careful with the roller kit position.
