Forester F4-2.5L Turbo (2009)
5) Install the cage to inner race fixed upon shaft.
NOTE:
Fit the cage with the protruding section aligned with the track on the inner race, and turn by a half pitch.
6) Fill 80 to 90 g (2.82 to 3.17 oz) of specified grease into the inner side of the DOJ outer race.
7) Apply a thin coat of specified grease to the cage pocket and six ball bearings.
8) Insert the six ball bearings into the cage pocket.
9) Align the outer race track and ball positions, and place the shaft, inner race, cage and ball bearings in the original positions, and then fix outer race
in place.
10) Install the snap ring in the groove on the DOJ outer race.
NOTE:
^
Assure that the balls, cage and inner race are completely fitted in the outer race of DOJ.
^
Use care not to place the matched position of snap ring in the ball groove of outer race.
^
Pull the shaft lightly and assure that the circlip is completely fitted in the groove.
