Forester F4-2.5L Turbo (2009)
8) Remove the transmission cushion rubber.
Installation
INSTALLATION
PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N-m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N-m (5.9 kgf-m, 42.8 ft-lb)
2) Install the air intake chamber and intake boot.
3) Connect the battery ground cable to the battery.
CROSS MEMBER AND CUSHION RUBBER
1) Install the transmission cushion rubber to the transmission, and tighten the bolt (A).
2) Install the transmission cushion rubber to the center crossmember, and tighten the nut (B).
Tightening torque:
Bolt (A): 35 N-m (3.6 kgf-m, 25.8 ft-lb)
NUT (B): 35 N-m (3.6 kgf-m, 25.8 ft-lb)
3) Install the front crossmember and rear crossmember.
Tightening torque:
