Forester S F4-2.5L DOHC (1998)
7. Disconnect connector from actuator, then remove the actuator.
8. Installation is in the reverse order of removal.
Tightening torque:
7.4 ± 2.0 N.m (0.75 ± 0.2 kg.m, 5.4 ± 1.4 ft.lb)
CAUTION: When inserting vacuum hose to intake manifold, apply sealant to the fitting hose.
Fluid packing: THREE BOND 1105 or equivalent
CAUTION:
-
Be careful not to apply excessive load to the wire cable when adjusting and/or installing; otherwise, the actuator may be deformed or damaged.
-
Do not bend cable sharply with a radius less than 100 mm (3.94 in); otherwise, cable may bend permanently, resulting in poor performance.
-
When installing cable, be careful not to sharply bend or pinch the inner cable; otherwise, the cable may break.
