Forester S F4-2.5L DOHC (1998)
4. Disconnect airbag connector (AB3) and (AB8) below steering column.
CAUTION: Do not reconnect airbag connector at steering column until airbag control module is securely re-installed.
5. Remove instrument panel console.
6. Disconnect 11-pin yellow connector (AB6) from airbag control module.
7. Using T40 TORX(R) bit (Tamper resistant type), remove four TORX(R) bolts in numerical sequence shown in figure. Discard the old TORX(R)
bolts.
CAUTION: Use new TORX(R) bolts during re-assembly.
8. Installation is in the reverse order of removal.
