Forester S F4-2.5L DOHC (1998)
Throttle Position Sensor: Service and Repair
THROTTLE POSITION SENSOR
A: REMOVAL AND INSTALLATION
1) Disconnect battery ground cable.
2) Disconnect connector from throttle position sensor.
3) Remove throttle position sensor holding screws, and remove it.
4) Installation is in the reverse order of removal.
Tightening torque: 2.2 ± 0.2 N.m (0.2 ± 0.02 kg-m, 1.6 ± 0.1 ft.lb)
CAUTION: When installing throttle position sensor, adjust to the specified data.
B: ADJUSTMENT
1) Turn ignition switch to OFF.
2) Loosen throttle position sensor holding screws.
3) When using voltage meter;
(1) Take out ECM.