Hatchback 4WD F4-1781cc 1.8L (1983)
3.
The clutch hub puller (SOA 624 880), can be used to remove the clutch hub. However, it will be necessary to place a small capscrew (8 mm hex
head) on the compressor shaft before installing the tool. This will ensure that the clutch hub is pulled completely off of the compressor shaft. (See
Figure 2).
4.
Place the clutch hub puller over the small capscrew and thread it into the clutch hub. Pull the clutch hub off of the compressor shaft by turning the
clutch hub puller center bolt clockwise with a 15 mm socket wrench while holding the clutch hub with the clutch hub spanner wrench. (See Figure
3).
