Hatchback 4WD F4-1781cc 1.8L (1983)
INSTALLATION INSTRUCTIONS FOR SUBARU REAR SEAT SHOULDER BELTS
Model applications:
3-Door Coupes 1986 thru 1988 4-Door Sedans 1985 thru 1988 (P/N 64174GA710)
CAUTION: Improper installation could adversely affect the performance of the seat belt system. Subaru of America strongly recommends these rear
seat shoulder belts be Installed by an Authorized Subaru Dealer.
1.
Remove rear seat lower cushion to provide access to the lap belt buckle mounting bolts.
2.
Remove and discard the 5/8 inch bolts which secure the original equipment lap belt buckles.
3.
Install each of the shoulder belt buckles using the attached 5/8 inch bolt and washers, on the top of the respective lap belt buckles. Properly
position as shown in Figure 1, tighten each bolt to specified torque, 18-25 foot pounds.
4.
Reinstall the rear seat cushion.
5.
Remove the upper quarter trim panels and transfer the position of the anchorage location to the trim panel. See Figure 2.
6.
Make 15/16" diameter holes through the trim panels making certain the holes line up with the anchorage location.
7.
Reinstall the trim panels and install the shoulder belt tongues utilizing the attached 5/8 inch bolts and attached washers. Tighten each bolt to
specified torque, 18-25 foot pounds. See Figure 2.
8.
Place the Use, safety Tips, and Maintenance Instructions in the Owner's Manual for future reference.
