Hatchback 4WD F4-1781cc 1.8L (1983)
INSTALLATION INSTRUCTIONS FOR SUBARU REAR SEAT SHOULDER BELTS
Model Applications:
XT 1985 through 1988 (P/N 64174GA720)
CAUTION:
Improper installation could adversely affect the performance of the seat belt system. Subaru of America strongly recommend's these rear
seat shoulder belts be installed by an Authorized Subaru Dealer.
1.
Remove rear seat lower cushion to provide access to the lap belt retractors mounting bolts.
2.
Remove and discard the 5/8 inch bolts which secure the original equipment lap belt retractors including belt tongues.
3.
Install each of the shoulder belt buckles using the attached 5/8 inch bolt and washers, with a spacer, on the top of the respective lap belt retractors
and tighten each bolt to specified torque, 18-25 foot pounds. See Figure 1.
4.
Reinstall the rear seat cushion.
5.
Remove both upper quarter trim panels and transfer the position at the anchorage location to the trim panel. See Figure 2.
6.
Make 15/16" diameter holes through trim panels making certain the holes line up with the anchorage location.
7.
Reinstall the trim panels and install the shoulder belt tongues utilizing the attached 5/8 inch bolts and washers. Tighten each bolt to specified
torque, 18-25 foot pounds. See Figure 2.
8.
Place the Use, Safety Tips, and Maintenance instructions in the Owner's Manual for future reference.
