Impreza 2.5 RS Coupe AWD F4-2.5L SOHC (2001)
2. Install front ABS sensor on strut and wheel apron bracket.
3. Place a thickness gauge between ABS sensor's pole piece and tone wheel's tooth face. After standard clearance is obtained over the entire
perimeter, tighten ABS sensor on housing to specified torque.
ABS sensor standard clearance:
0.3 - 0.8 mm (0.012 - 0.031 inch)
Tightening torque:
32 Nm (3.3 kgf-m, 24 ft. lbs.)
CAUTION: Check the marks on the harness to make sure that no distortion exists. (RH: while, LH: yellow)
NOTE: If the clearance is outside specifications, readjust.
