Impreza 2.5 RS Coupe AWD F4-2.5L SOHC (2001)
8. Remove steering column covers.
9. Removing three retaining screws, remove combination switch.
INSTALLATION
CAUTION: Failure to do this might damage roll connector.
1. Before installing combination switch, check to ensure that combination switch is off and front wheels are set in the straight ahead position.
2. Install column cover and center roll connector.
ADJUSTMENT
CENTERING ROLL CONNECTOR
Before installing steering wheel, make sure to center roll connector built into combination switch.
1. Make sure that front wheels are positioned straight ahead.
2. Install steering gearbox, steering shaft and combination switch properly. Turn roll connector pin (A) clockwise until it stops.
3. Then, back off roll connector pin (A) approximately 2.5 turns until "A" marks aligned.
NOTE: If steering wheel angle requires fine adjustment, adjust tie-rod.
4. Install airbag module and lower cover in the reverse order of removal.
