subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Impact Sensor|Service and Repair > < Component Locations|Page 492
Page 1
background image

Impact Sensor: Testing and Inspection

INSPECTION

If the vehicle equipped with an SRS airbag system is damaged in a collision, the airbag system parts must be checked and replaced in accordance with
the following standards:

-

After faulty parts are replaced, the warning light operation must be checked.

-

When the ignition switch is turned ON, it lights up for 8 seconds and then it goes out for at least 30 seconds.

-

The trouble code stored in memory must be erased after the check.

FRONT SUB SENSOR

INSPECTION STANDARD

-

Check the front section (Refer to shaded area of vehicle in figure) for damage, regardless of whether or not airbag is deployed.

-

The designated trouble code is output during self-diagnosis. 

REPLACEMENT STANDARD

-

Bracket is deformed.

-

Housing is cracked or deformed.

-

The label (that identifies the manufacturing number) is peeled or deteriorated.

-

Harness circuit is broken, lead wire is exposed, corrugated tube is cracked, etc.

-

Front sub sensor determined as faulty as a result of Diagnostics.

-

Airbag is deployed.

-

Front sub sensor dropped to the floor/ground.

Impact Sensor|Service and Repair > < Component Locations|Page 492