Impreza 2.5 RS Coupe AWD F4-2.5L SOHC (2001)
2. Tighten the six bolts to install the select lever to the vehicle body, then connect connectors.
Tightening torque: 4.5 Nm (0.46 kgf-m, 3.3 ft. lbs.)
3. Install console box.
4. Set location of select lever at "N" position.
5. Set location of selector arm installed on the transmission body at "N" position.
6. Pass inner cable through selector arm pin and then connect it using a washer and snap pin.
7. Attach outer cable to plate on transmission case with the bolts.
Tightening torque: 33 Nm (3.4 kgf-m, 25 ft. lbs.)
8. Insert the thread portion of the other inner cable and into the connector hole of the select lever, and fix the other outer cable end to the bracket.
Tightening torque: 18 Nm (1.8 kgf-m, 13.0 ft. lbs.)
9. Adjust the inner cable length.
1. Put connector into contact with nut (A).
2. Tighten nut (B).
Tightening torque: 7.4 Nm (0.75 kgf-m, 5.4 ft. lbs.)
10. After completion of fitting, make sure that the select lever operates smoothly all across the operating range.
11. Connect the harnesses and check the following items.
1. The engine starts operating when select lever is in position "P", but not in other positions.
2. The back-up light is lit when the select lever is in position "R", but not in other positions.
