Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
To facilitate installation, fit the boot starting with piston end.
6) Position the boot in grooves on cylinder and piston.
7) Install the boot ring. Be careful not to scratch the boot.
8) Apply a coat of specified grease to lock pin and guide pin, outer surface, cylinder inner surface, and boot grooves.
Grease: NIGLUBE RX-2 (Part No. 003606000)
9) Install the lock pin boot and guide pin boot on support.
Rear
DISASSEMBLY
1) Remove the boot ring.
2) Remove the piston boot.
3) Gradually supply compressed air via inlet of caliper body to force piston out.
