Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
Brake Rotor/Disc: Service and Repair
Front
The content of this article/image reflects the changes Identified in
TSB # 18-101-06
as of 02/13/2006
and applies to 2002 Legacy, Forester & Impreza Models
REMOVAL
1) Set the vehicle on the lift.
2) Loosen the wheel nuts.
3) Jack-up the vehicle, and remove the front wheel.
4) Remove the caliper body from housing, and suspend it from strut using a wire.
5) Remove the disc rotor.
NOTE: If the disc rotor seizes up within the hub, drive the disc rotor out by installing an 8-mm bolt in holes B on the rotor.
6) Clean mud and foreign particles from the caliper body assembly and support.
INSTALLATION
1) Install the disc rotor.
2) Install the caliper body on housing.
Tightening torque: 80 Nm (8.2 kgf-m, 59 ft. lbs.)
3) Install the wheel.