Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
A/C Coupler O-ring: Description and Operation
O-RING CONNECTIONS
-
Use new O-rings.
-
In order to keep the O-rings free of lint which will cause a refrigerant gas leak, perform operations without gloves and shop towels.
-
Apply the compressor oil to the O-rings to avoid sticking, then install them.
-
Use a torque wrench to tighten the O-ring fittings: Over-tightening will damage the O-ring and tube end distortion.
-
If the operation is interrupted before completing a pipe connection, recap the tubes, components, and fittings with a plug or tape to prevent
contamination from entering.
-
Visually check the surfaces and mating surfaces of O-rings, threads, and connecting points. If a failure is found, replace the applicable parts.
-
Install the O-rings at right angle to the tube beads.
-
Use the oil specified to lubricate the O-rings.
Apply the oil to the top and sides of the O-rings before installation.
Apply the oil to the area including the O-rings and tube beads.
-
After tightening, use a clean shop towel to remove excess oil from the connections and any oil which may have run on the vehicle body or other
parts.
-
If any leakage is suspected after tightening, do not retighten the connections, Disconnect the connections, remove the O-rings, and check the
O-rings, threads, and connections.
