subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Power Steering Line/Hose|Service and Repair|Page 886 > < Hose/Line HVAC|Service and Repair
Page 1
background image

Power Steering Line/Hose: Service and Repair

A: REMOVAL 

1. Disconnect the battery ground terminal. 

2. Lift the vehicle and remove the jack-up plate.
3. Remove one pipe joint at the center of gearbox, and connect a vinyl hose to the pipe and joint. Discharge the fluid by turning steering wheel fully

clockwise and counterclockwise. Discharge the fluid similarly from the other pipe.

CAUTION:  Improper removal and installation of parts often causes fluid leak trouble. To prevent this, clean the surrounding portions before
disassembly and reassembly, and pay special attention to keep dirt and other foreign matter from mating surfaces.

4. Remove the clamp E from pipes C and D.
5. Disconnect the pipe C, D from the pipe (on the gearbox side).

CAUTION:  
^

When disconnecting pipe C, D use two wrenches to prevent deformities.

^

Be careful to keep pipe connections free from foreign matter.

Power Steering Line/Hose|Service and Repair|Page 886 > < Hose/Line HVAC|Service and Repair