Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
3. Apply proper amount of liquid gasket to the entire oil pan mating surface. Fluid packing: Three Bond 1217B
4. Install the oil pan.
Tightening torque: 25 Nm (2.5 kgf-cm, 18.1 ft. lbs.)
5. Install the front and rear vehicle speed sensor, and also the torque converter turbine speed sensor, and then fasten the harness.
Tightening torque: 7 Nm (0.7 kgf-cm, 5.1 ft. lbs.)
6. Install the oil cooler outlet pipe.
CAUTION: Be sure to use a new aluminum washer.
Tightening torque: 25 Nm (2.5 kgf-cm, 18.1 ft. lbs.)
7. Install the transmission rear crossmember bolts.
Tightening torque: 75 Nm (7.6 kgf-cm, 55 ft. lbs.)
8. Install the propeller shaft.
9. Install the shield cover. (If equipped)
10. Install the front, center, rear exhaust pipes and muffler. (Non-turbo model)
11. Install the center, rear exhaust pipes and muffler. (Turbo model)
12. Lower the vehicle.
13. Install the transmission connector to the stay.
14. Install the air cleaner case. (Non-turbo model)
15. Install the intercooler. (Turbo model).
Rear Speed Sensor
A: REMOVAL
When removing the rear vehicle speed sensor, refer to "Front Vehicle Speed Sensor."
B: INSTALLATION
When installing the rear vehicle speed sensor, refer to "Front Vehicle Speed Sensor."
