Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
Vehicle Speed Sensor: Service and Repair
A/T
Front Speed Sensor
A: REMOVAL
1. Set up the vehicle on the lift.
2. Disconnect the ground terminal from battery.
3. Remove the air cleaner case. (Non-turbo model)
4. Remove the intercooler. (Turbo model)
5. Disconnect the transmission connector.
6. Remove the transmission connector from stay.
7. Lift-up the vehicle.
8. Clean the transmission exterior.
9. Drain the ATF completely.
NOTE: Tighten the ATF drain plug after draining the ATF.
Tightening torque: 25 Nm (2.5 kgf-cm, 18.1 ft. lbs.)
10. Remove the front, center, rear, exhaust pipes and muffler.
11. Remove the center, rear exhaust pipes and muffler. (Turbo model)
12. Remove the shield cover.
13. Remove the propeller shaft.
14. Place the transmission jack under crossmember.
