Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
3. Install the rear vehicle speed sensor.
Tightening torque:
T: 7 Nm (0.7 kgf-cm, 5.1 ft. lbs.)
4. Install the rear crossmember.
1. Tighten the bolts.
Tightening torque:
T1: 35 Nm (3.6 kgf-cm, 26 ft. lbs.)
T2: 70 Nm (7.1 kgf-cm, 51.4 ft. lbs.)
2. Lower and remove the transmission jack.
5. Install the propeller shaft.
6. Install the front exhaust pipe and center exhaust pipe.
7. Lower and remove the jack.
8. Connect the transmission harness connector.
9. Install the pitching stopper.
Tightening torque:
T1: 50 Nm (5.1 kgf-cm, 37 ft. lbs.)
T2 58 Nm (5.9 kgf-cm, 43 ft. lbs.)
10. Install the air cleaner case and duct.
11. Fill ATF up to the middle of the "COLD" side on level gauge by using the gauge hole.
12. Check the ATF level.
