subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Sensors and Switches - Transmission and Drivetrain > < Integrated Module
Page 1
background image

Control Module: Service and Repair
Transmission Control Module

A: REMOVAL 

1. Disconnect the ground terminal from battery.

2. Remove the lower cover and then disconnect the connector.

3. Disconnect the connectors from transmission control module.
4. Remove the transmission control module.

B: INSTALLATION 

1. Install the transmission control module.

Tightening torque: 7.5 Nm (0.76 kgf-cm, 5.5 ft. lbs.)

2. Connect the connectors to transmission control module. 
3. Install in the reverse order of removal.

Sensors and Switches - Transmission and Drivetrain > < Integrated Module