Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
Engine Control Module: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the lower inner trim of passenger side.
3. Detach the floor mat of front passenger seat.
4. Remove the protect cover.
5. Remove the nuts (A) which hold ECM to the bracket.
6. Remove the clip (B) from the bracket.
7. Disconnect the ECM connectors and take out the ECM.
INSTALLATION
Install in the reverse order of removal.
CAUTION: When replacing ECM, be careful not to use the wrong spec. ECM to avoid any damage to the fuel injection system.
Tightening Torque: .......................................................................................................................................................... 50 Nm (0.51 kgf-m, 3.7 ft. lbs)
