Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
Roll Connector: Service and Repair
STEERING ROLL CONNECTOR / REMOVAL
1. Turn the ignition switch OFF.
2. Disconnect the ground terminal from battery, and wait for at least 20 seconds before starting work.
3. Remove the driver's airbag module.
4. Remove the steering wheel.
5. Remove the steering column cover.
6. Remove the screws, and then remove the roll connector.
INSTALLATION
1. Install the roll connector and steering column cover in the reverse order of removal.
2. *Before installing steering wheel, be sure the direction of roll connector is adjusted with steering.
3. Install the steering wheel and airbag module.
Roll Connector
*ADJUSTMENT
1. Check that front wheels are positioned in straight ahead direction.
2. Turn roll connector pin (A) clockwise until it stops.
3. Turn roll connector pin (A) counterclockwise approximately 2.65 turns until " " marks are aligned.
