subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Propeller Shaft|Page 3847 > < Propeller Shaft|Page 3845
Page 7
background image

20. Pinch the end of band with pliers. Hold the clip and tighten securely.

NOTE:  When tightening boot, exercise care so that the air within the boot is appropriate.

21. Tighten the band by using ST.

ST 925091000 BAND TIGHTENING TOOL

NOTE:  Tighten the band until it cannot be moved by hand.

22. Tap on the clip with the punch provided at the end of ST. 

ST 925091000 BAND TIGHTENING TOOL

CAUTION:  Tap to an extent that the boot underneath is not damaged.

23. Cut off band with an allowance of about 10 mm (0.39 inch) left from the clip and bend this allowance over the clip.

CAUTION:  Be careful so that the end of the band is in close contact with clip.

24. Fix up boot on the EBJ in the same manner.

NOTE:  Extend and retract the SFJ to provide equal grease coating.

Propeller Shaft|Page 3847 > < Propeller Shaft|Page 3845