Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
6. Fill 80 to 90 g (2.82 to 3.17 oz) of specified grease into the interior of DOJ outer race.
7. Apply a coat of specified grease to the cage pocket and six balls.
8. Insert six balls into the cage pocket.
9. Align the outer race track and ball positions and place in the part where shaft, inner race, cage and balls are previously installed, and then fit outer
race.
10. Install the circlip in the groove on the DOJ outer race.
NOTE:
^
Assure that the balls, cage and inner race are completely fitted in the outer race of DOJ.
^
Exercise care not to place the matched position of circlip in the ball groove of outer race.
^
Pull the shaft lightly and assure that the circlip is completely fitted in the groove.
11. Apply an even coat of the specified grease [20 to 30 g (0.71 to 1.06 oz)] to the entire inner surface of boot. Also apply grease to shaft.
12. Install the DOJ boot taking care not to twist it.
NOTE:
^
The inside of the larger end of DOJ boot and the boot groove shall be cleaned so as to be free from grease and other substances.
^
When installing DOJ boot, position outer race of DOJ at center of its travel.
13. Put a band through the clip and wind twice in alignment with band groove of boot.
CAUTION: Use a new band.
14. Pinch the end of band with pliers. Hold the clip and tighten securely.
NOTE: When tightening boot, exercise care so that the air within the boot is appropriate.
15. Tighten the band by using ST.
ST 925091000 BAND TIGHTENING TOOL
NOTE: Tighten the band until it cannot be moved by hand.
