subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Manual Transmission/Transaxle > < M/T - Cold Clutch Judder|Page 3878
Page 1
background image

Flywheel: Service and Repair

A: REMOVAL

1. Remove the transmission assembly. 
2. Remove the clutch cover and clutch disc. 

CAUTION:

^

Take care not to allow oil on the clutch disc facing.

^

Do not disassemble either the clutch cover or clutch disc. 

3. Using ST, remove the flywheel. 

ST 498497100 CRANKSHAFT STOPPER

B: INSTALLATION 

1. Install the flywheel and ST.

ST4 98497100 CRANKSHAFT STOPPER

2. Tighten the flywheel attaching bolts to the specified torque.

NOTE:  Tighten the flywheel installing bolts gradually. Each bolt should be tightened to the specified torque in a crisscross method.

Tightening torque: 72 Nm (7.3 kgf-cm, 52.8 ft. lbs.)

3. Install the clutch disc and cover.  
4. Install the transmission assembly. 

Manual Transmission/Transaxle > < M/T - Cold Clutch Judder|Page 3878