subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Gear, M/T > < Fluid - M/T|Capacity Specifications|Page 3898
Page 1
background image

Fluid - M/T: Service and Repair

REPLACEMENT

1. Pull out oil level gauge. 
2. Lift-up the vehicle. 

3. Drain the transmission gear oil completely.

CAUTION: Directly after the engine has been running, the transmission gear oil is hot. Be careful not to burn yourself.

NOTE:  Tighten the transmission gear oil drain plug after draining transmission gear oil.

Tightening torque: 44 Nm (4.5 kgf-cm, 32.5 ft. lbs.)

4. Lower the vehicle.
5. Pour the gear oil into the gauge hole.

Recommended gear oil: Use GL-5 or equivalent.
Gear oil capacity: 3.5 L (3.7 US qt, 3.1 Imp qt) 

6. Check the level of the transmission gear oil.

CAUTION: When inserting the level gauge into transmission gear, align the protrusion on the side of the top part of the level gauge with
the notch in the gauge hole.

NOTE:   The level should be within the specified range marked on the gauge.

Gear, M/T > < Fluid - M/T|Capacity Specifications|Page 3898