Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
3. Install the intercooler. (Turbo model)
4. Connect the battery ground terminal.
2. CROSSMEMBER AND CUSHION RUBBER
1. Install for rear cushion rubber.
Tightening torque: 35 Nm (3.6 kgf-cm, 26 ft. lbs.)
2. Install the crossmember.
Tightening torque:
T1: 70 Nm (7.1 kgf-cm, 51 ft. lbs.)
T2: 140 Nm (14.3 kgf-cm, 103 ft. lbs.)
3. Remove the transmission jack.
4. Install the heat shield cover. (If equipped)
5. Install the front and center exhaust pipes. (Non turbo model)
6. Install the center exhaust pipe. (Turbo model)
7. Install the rear exhaust pipe and muffler.
