Impreza Coupe FWD F4-1820cc 1.8L SOHC (1995)
1. While operating knob (located on top of backrest), lift headrest out by placing your hand between backrest and head rest.
2. Pull reclining lever back to fold backrest all the way forward. Pull slide adjuster lever and move lower slide rail all the way backward.
3. Position seat in compartment and align the holes on the seat with the holes on the car body side.
4. Secure the front of seat using inward and outward bolts (1) and (2) in that order.
5. While pulling slide adjuster lever, move seat all the way forward.
6. Secure the rear of seat using inward and outward bolts (3) and (4).
7. Install bolt (5)
CAUTION: Check that all lock plate pawls are completely and equally inserted into the holes in the slide rail brackets.
8. After installation, ensure that all mechanisms operate properly and lock.
9. If any mechanism does not function properly, loosen bolts (3), (4) and (5), slide seat as required, insert all lock plate pawls into holes in slide rail
brackets, and tighten bolts (3), (4) and (5) in that order.
10. Install bolt cover on rear end of slide rail.
11. Install headrest on backrest.
NOTE: Tighten bolts in the designated order.
