Impreza Coupe FWD F4-1820cc 1.8L SOHC (1995)
7) Connect pipes A and B to four pipe joints of gearbox.
Connect upper pipe B first, and lower pipe A second.
Tightening torque:
13 ± 3 Nm (1.3 ± 0.3 kg-m, 9.4 ± 2.2 ft-Ib.)
8) Install jack-up plate.
9) Connect battery minus terminal.
10) Feed the specified fluid and discharge air.
NOTE; Never start the engine before feeding the fluid; otherwise vane pump might be seized up.
11) Finally check clearance between pipes and/or hoses, as shown above.
If clearance between cruise control pump and power steering hose is less than 10 mm (0.39 in), proceed as follows:
(1) Move clamped section (A) (refer to figure above) down to a point where pipe is close to crossmember (pipe-to-crossmember clearance; 10
mm (0.39 in), mm.).
(2) Check that clearance between cruise control pump and power steering hose is at least 10 mm (0.39 in). If it is not, bend section (B) down
until a clearance of at least 10 mm (0.39 in) is obtained.
