Impreza Coupe FWD F4-1820cc 1.8L SOHC (1995)
5) Fit ST1 and ST2 over the end of rack, and install rack bushing.
ST1 926400000 GUIDE
ST2 927660000 GUIDE
CAUTION:
-
If burrs, or nicks are found on this guide and rack shaft portion, remove by filing.
-
Dip rack bushing in ATF DEXRON II before installing, and pay attention not to damage O-ring and oil seal.
6) Insert rack stopper into cylinder tube until internal groove (on cylinder side) is aligned with external groove (on rack stopper). Turn rack
stopper with ST so that rack stopper hole is seen through cylinder slits.
7) Insert rack stopper into rack housing, and wrap circlip using ST to secure rack stopper in position. ST 926340001 WRENCH
CAUTION: Be careful not to scratch rack while winding circlip.
NOTE: Rotate wrench another 90 to 180° after the end of circlip has been wrapped in.
8) Fit mounting rubber onto rack housing.
VALVE ASSEMBLY
1) Apply genuine grease to pinion gear and bearing of valve assembly.
