Impreza Coupe FWD F4-1820cc 1.8L SOHC (1995)
Control Arm: Service and Repair
Assembly
FRONT BUSHING
To reassemble, reverse disassembly procedures.
CAUTION: Install front bushing in correct direction, as shown in figure.
REAR BUSHING
1) Install rear bushing to transverse link and align aligning marks scribed on the two.
2) Tighten self-locking nut.
CAUTION:
-
Discard loosened self-locking nut and replace with a new one.
-
While holding rear bushing so as not to change position of aligning marks, tighten self-locking nut.
Tightening torque:
196 ± 25 Nm (20.0 ± 2.5 kg-m, 145 ± 18 ft-Ib.)
