subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Door Trim|Page 4686 > < Door Trim|Page 4684
Page 4
background image

1. Remove the clips, then lift the door trim.

NOTE:  Insert a plastic clip remover into the slit at the bottom of the door trim, to lift the door trim.

2. Remove the cable (1) and (2) from the cable holder of inner remote.

3. Disconnect the harness connector and remove the door trim.

2. REAR DOOR

1. Disconnect the ground cable from battery.
2. Remove the gusset cover.

1. Push gusset cover in direction of vehicle front to detach the claws (A) on the backside of the gusset cover.

2. Insert a plastic remover into to the position shown in the figure while retaining the condition in step (1), and lift up the gusset cover.

Door Trim|Page 4686 > < Door Trim|Page 4684