Impreza GT F4-2.5L Turbo (2009)
Air Bag(s) Arming and Disarming: Service and Repair
CAUTION
-
When servicing a vehicle, be sure to turn the ignition switch to OFF, disconnect the ground cable from battery, and wait for 20 seconds or more
before starting work.
-
The airbag system is fitted with a backup power supply. After disconnecting the battery ground cable, the airbag may deploy if you do not wait for
20 seconds or more before starting airbag system servicing.
-
If the airbag warning light illuminates, check or repair the vehicle immediately to prevent it from airbag system malfunction.
-
If any of the airbag sensors, airbag module, airbag control module, pretensioner, harness or satellite safing sensor cover is deformed or damaged,
replace with new parts.
-
When checking the airbag system, be sure to use a digital circuit tester. Use of an analog circuit tester may cause the airbag to activate erroneously
due to a minimal current inside tester.
-
When checking, use a test harness (1). Damage to connector terminal cause malfunction. Do not directly apply the tester probe to connector
terminal of airbag.