Impreza GT F4-2.5L Turbo (2009)
CAUTION:
If brake fluid is spilled on the vehicle body, wash it off immediately with water and wipe clean.
7) Loosen the nuts and remove the ABSCM&H/U.
CAUTION:
-
Do not drop or bump the ABSCM&H/U.
-
Do not turn the ABSCM&H/U upside down or place it sideways for storage.
-
Be careful not to let foreign matter enter into ABSCM&H/U.
-
Be careful that no water enters the connectors.
8) Remove the ABSCM&H/U bracket.
INSTALLATION
1) Install the ABSCM&H/U bracket.
Tightening torque:
33 Nm (3.4 kgf-m, 24.3 ft-lb)
2) Install the ABSCM&H/U using new nuts (Part No. 023506000) by aligning the damper groove of the ABSCM&H/U to the bracket side claw.
NOTE:
Check the identification marks of the ABSCM&H/U.
Tightening torque:
7.5 Nm (0.76 kgf-m, 5.5 ft-lb)
3) Connect the brake pipes to their correct ABSCM&H/U positions.
Tightening torque:
15 Nm (1.5 kgf-m, 11.1 ft-lb)
4) Using a harness clip, secure the ABSCM&H/U harness to the bracket.
5) Connect the connector to ABSCM&H/U.
NOTE:
-
Be sure to remove all foreign matter from inside the connector before connecting.
-
Make sure the ABSCM&H/U connector is securely locked.
6) Bleed air from the brake system.
REPLACEMENT