Impreza GT F4-2.5L Turbo (2009)
9. Remove the bolts and nuts which hold fuel sub level sensor to the fuel tank.
10. Remove the fuel sub level sensor.
INSTALLATION
Install in the reverse order of removal while being careful of the following.
-
Make sure the sealing portion is free from fuel or foreign matter before installation.
-
Align protrusion (A) of the gasket to the position shown in the following figure.
-
Align protrusion (B) of the fuel sub level sensor to the cut out in the fuel sub level sensor upper plate.
-
Tighten the nuts and bolts to the specified torque in the order as shown in the figure.
-
After tightening, install the rubber cap (C) shown in the figure.
NOTE:
-
Use a new gasket and retainer.
-
Do not forget to install rubber cap (C).
