Impreza GT F4-2.5L Turbo (2009)
Installation
INSTALLATION
1) Using the ST, install the stud bolt.
ST 20299AG020 STUD BOLT SOCKET
Tightening torque:
110 N-m (11.2 kgf-m, 81.1 ft-lb)
2) Using new bolts and self-locking nuts, temporarily tighten the front arm to crossmember.
3) Secure the front arm to body, and then install the support plate with new bolts and self-locking nuts.
Tightening torque:
Support plate to Front arm:
110 N-m (11.2 kgf-m, 81.1 ft-lb)
Support plate to Body:
150 N-m (15.3 kgf-m, 110.6 ft-lb)
4) Install the ball joint into housing.
Tightening torque:
50 N-m (5.1 kgf-m, 36.9 ft-lb)
5) Install the stabilizer.
6) Install the front wheels.
7) Lower the vehicle from lift, and tighten the bolt which secures the front arm to crossmember with wheels in full contact with the ground and the
vehicle at curb weight.
Tightening torque:
95 N-m (9.7 kgf-m, 70.1 ft-lb)
8) Inspect the wheel alignment and adjust if necessary.
Removal
Rear Trailing Link
REMOVAL
1) Lift up the vehicle, and then remove the rear wheels.
2) Remove the bracket, and remove the parking brake cable from the guide.
