Impreza GT F4-2.5L Turbo (2009)
Suspension Strut / Shock Absorber: Procedures
Front Suspension
DISPOSAL
CAUTION:
^
Before handling struts, be sure to wear goggles to protect eyes from gas, oil and cutting powder.
^
Do not disassemble the strut damper or throw into flames.
^
When discarding gas filled struts, drill holes in them to purge the gas.
1) Place the strut on a level surface with the piston rod fully expanded.
2) Using a 2 - 3 mm (0.08 - 0.12 in) dia. drill, make holes in areas shown in the figure.
Rear Suspension
DISPOSAL
CAUTION:
^
Before handling the shock absorber, be sure to wear goggles to protect eyes from gas, oil and cutting powder.
^
Do not disassemble the shock absorber or place it into a fire.
^
Drill a hole into shock absorbers in case of discarding shock absorbers filled with gas.
1) Place the shock absorber on a level surface with the piston rod fully expanded.
2) Make a hole into the specified position 30 mm (1.18 in) deep using a drill with 2 - 3 mm (0.08 0.12 in) diameter.
