Impreza GT F4-2.5L Turbo (2009)
5) Install the oil pan and the control valve assembly.
6) Turn over the transmission case to its original position.
7) Install the pitching stopper bracket.
Tightening torque:
41 N-m (4.2 kgf-m, 30.2 ft-lb)
8) Install and adjust the inhibitor switch.
9) Insert the inhibitor switch connector and transmission harness connector onto the stay.
10) Install the air breather hose.
11) Insert the input shaft while rotating it lightly by hand, and then check the amount of protrusion.
Normal protrusion A:
50 - 55 mm (1.97 - 2.17 in)
12) Install the torque converter clutch assembly.
13) Install the transmission assembly to the vehicle.
INSPECTION
Make sure that the manual lever and detent spring are not worn or otherwise damaged.
