subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Speedometer Head > < Diagram Information and Instructions|Page 4627
Page 1
background image

Speedometer Cable: Service and Repair

REMOVAL 

1) Remove speedometer cable, starting with its midpoint connection inside engine compartment.
2) While holding up boot located at speedometer cable connection, slightly expand clip. Extract speedometer cable by pulling it upward 2 to 3 mm

(0.08 to 0.12 inch) on speedometer side. Then, release clip and remove speedometer cable.

3) After disconnecting cable from speedometer, pull it out of toe board.
4) Remove screw which secures speedometer cable to transmission side.

INSTALLATION 

1) After manually screwing speedometer cable on transmission side, tighten it 45 to 90° using a wrench.
2) Securely install boot onto midpoint connection of speedometer cable to prevent entry of water.

Speedometer Head > < Diagram Information and Instructions|Page 4627