Impreza L Sport Wagon F4-2.2L SOHC (1999)
CAUTION: Use a new self-locking nut.
5. Clean brake pipe connection. Using a flare-nut wrench, connect brake pipe to wheel cylinder.
6. Connect parking brake cable to lever.
7. Install brake drum on rear housing assembly.
8. Install rear speed sensor to back plate (only vehicle equipped with ABS).
9. Bleed air from brake system. Refer to Brakes and Traction Control.
10. Adjust parking brake lever stroke by turning adjuster.
11. Move brake lever back to apply brakes. While depressing brake pedal, tighten axle nut using a socket wrench. Lock axle nut after tightening.
Tightening torque: 186 ± 20 Nm (137 ± 14 ft. lbs.).
CAUTION:
^
Use a new axle nut.
^
Always tighten axle nut before installing wheel on vehicle. If wheel is installed and comes in contact with ground when axle nut is loose,
wheel bearings may be damaged.
^
Be sure to tighten axle nut to specified torque. Do not overtighten it as this may damage wheel bearing.
12. Install wheel and tighten wheel nuts to specified torque.
Tightening torque: 88 ± 10 Nm (65 ± 7 ft. lbs.).
