Impreza Outback Sport AWD F4-2.5L SOHC (2002)
Brake Pedal Assy: Service and Repair
Removal and Installation
REMOVAL
1. MT MODEL
1) Remove the steering bolts.
2) Raise the vehicle on hoist and remove the two bolts which secure steering unit to underside of body.
3) Lower the vehicle to floor.
4) Remove the instrument panel lower cover from instrument panel.
5) Disconnect the following parts from pedal bracket.
^
Operating rod of brake booster
^
Electrical connectors (for stop light switch, etc.)
6) Remove the clevis pin which secures lever to push rod.
7) Remove the nut which secures clutch master cylinder.
8) Remove the steering assembly.
9) Remove the accelerator pedal.
10) Remove the bolts and nuts which secure pedal bracket.
2. AT MODEL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover from instrument panel.
3) Remove the clevis pin which secures brake pedal to brake booster operating rod. Also disconnect the stop light switch connector.
4) Remove the two bolts and four nuts which secure brake pedal to pedal.
INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
^
If the cable clamp is damaged, replace it with a new one.
^
Never fall to cover the outer cable end with boot.
^
Be careful not to kink the accelerator cable.
^
Always use new clevis pins.
2) Adjust the clutch pedal
3) Inspect after pedal installation