Impreza Outback Sport AWD F4-2.5L SOHC (2002)
3) Apply a thin coat of Molykote AS88ON (Part No. 26298AC000) to the frictional portion between pad and inner shim.
4) Install the pads on support.
5) Install the caliper body on support.
Tightening torque:
Non-turbo model: 26.5 Nm (2.70 kgf-m, 19.5 ft. lbs.)
Turbo model: 37 Nm (3.8 kgf-m, 27.5 ft. lbs.)
6) Connect the brake hose.
Tightening torque: 18 Nm (1.8 kgf-m, 13.0 ft. lbs.)
CAUTION: Replace the brake hose gaskets with new ones.
7) Bleed air from the brake system.
Rear
REMOVAL
CAUTION: Do not allow brake fluid to come in contact with the vehicle body; wipe off completely if spilled.
1) Set the vehicle on the lift.
2) Loosen the wheel nuts.
3) Lift-up the vehicle and remove the wheels.
4) Disconnect the brake hose from caliper body assembly.
5) Remove the lock pin.
6) Raise the caliper body and move it toward the vehicle center to separate it from support.
7) Remove the support from back plate.
NOTE: Remove the support only when replacing it or the rotor. It need not be removed when servicing the caliper body assembly.
8) Clean mud and foreign particles from the caliper body assembly and support.
CAUTION: Be careful not to allow foreign particles to enter inlet (at brake hose connector).
INSTALLATION
1) Install the disc rotor on hub.
2) Install the support on back plate.
Tightening torque: 53 Nm (5.4 kgf-m, 39.1 ft. lbs.)
CAUTION:
^
Always replace the pads for both the left and right wheels at the same time. Also replace the pad clips if they are twisted or worn.
^
A wear indicator is provided on the inner disc brake pad. If the pad wears down to such an extent that the end of the wear indicator contacts the
disc rotor, a squeaking sound is produced as the wheel rotates. If this sound is heard, replace the pad.
